Back to Blog
Multipsk full version6/9/2023 ![]() This brings up the I/Q direct screen with the waterfall and should be showing red bands where each freq is. 1545035khz for an Aero freq and click ForwardĨ. Enter your freq in the box under 'Manual frequency' - eg. Select AERO in the modes screen and then click the 'Transceiver' button top of screenħ. Click on RX/TX screen to take you to the main MultiPSK screenĦ. If you need to turn on Bias-T, click the button 'Options (port/address)' under the 'SDRplay' button and click the Bias-T boxĥ. ![]() In the 'Configuration' screen click the button 'SDRPlay' and the words 'SDRplay receiver detected and TCP/IP connection done' will appear in the blank line below the RX/TX screen button.\Ĥ. Run MultiPSK (Must be the latest full version, not the free one)ģ. To use MultiPSK with a RSP2, I do as follows:-Ģ. I am currently using it to decode Aero traffic from the Inmarsat satellite using a patch antenna. There should be no problem in getting the RSP receivers to work with MultiPSK.
0 Comments
Read More
Leave a Reply. |